Arcadia D3 Forest (6%) UVB T5 HO

$39.95$50.95

  • For Forest Species
  • 6% UVB for the synthesis of vitamin D3
  • 30% UVA
  • Produces excellent natural colours
Clear
SKU: N/A Categories: , , ,

Description

**Please note, not all items are currently in stock (stock number will be indicated on each product), Pre-Ordering is available, next shipment is expected week ending June 17th**

Offering a significant increase in both visible light and UV output compared with T8 lamps of similar length.

  • For Forest Species
  • 6% UVB for the synthesis of vitamin D3
  • 30% UVA
  • Produces excellent natural colours
  • 200%+ more visible light than equivalent length D3 T8 lamp (un-reflected)
  • 80% more UVB than equivalent length T8 lamp (un-reflected)
LENGTH Watt Diameter Lumens Temp UV-A UV-B
22″/550mm 24W T5-16mm 1050lm 7000K 30% 6%
34″/850mm 39W T5-16mm 2000lm 7000K 30% 6%
46″/1150mm 54W T5-16mm 3000lm 7000K 30% 6%

 

Product Safety

Lamps can be fragile pieces of equipment. Please follow the following steps to ensure the safe fitting and use of fluorescent lamps.

At either end of a fluorescent lamp you will see two brass coloured connection pins. These are the electrodes that take energy from the controller to start and run the lamp. These are quite fragile by nature. It is imperative that both pins are safely located into the pin sockets inside the lamp holder before the lamp is pressed into place. Failure to line the pins up correctly will cause the pins to bend and snap and break through the lamp cap rendering the lamp unusable.
The Ultra-seal lamp ring must be unscrewed from the lamp holder and placed over the lamp prior to fitting and only re-seated onto the lamp holder when you are sure that the lamp pins are seated correctly. High Output T5 lamp leads must be fully unwound also or you may notice lamp flickering or beaks in illumination. You can also use a very small amount of a substance like Vaseline to lubricate the lamp ring and so stop it fusing to the lamp after long periods of heat. After cooling lamps can be wiped clean with a damp cloth once every two weeks or so to remove any dust build up from the lamp, this in turn will help to maintain the lamps full output. The all important reflector should also be wiped clean at the same time.

Additional information

Dimensions N/A
Length

22", 34", 46"